特价供应 日立V-1050F模拟示波器 100MHz/0.5mv/2ns/双踪 双时基扫描 厂家: 日本日立 尺寸: 32×19×42cm 重量: 11kg ●示波管 Hitach 15OBNB31 Screen type : P31 phosphor standard 内刻度 自动聚焦 ●Z-AXIS DC-coupled, positive—going signal decreases intensity: 5Vp-p Signal causes noticeable modulation at normal intensity: DC to 3.5MHz. Input impedance: Approximately 15 kΩ Maximum input voltage: 20 V (DC + AC peak) Coupling: DC ●VERTICAL DEFLECTION (2 Identical Channels) Bandwidth and Rise time DC to at least 100MHz and rise time 3.5ns or less. DC to at least 5MHz and rise time 7Ons c less at magnifier extends. Lower -3dB point, AC coupling 10Hz or less. Deflection Factor 5mV/div to 5V/div in 10 calibrated steps, 1-2-5 sequence. Uncalibrated continuous control extends deflection factor to at least 12.5 Volt per division in the 5 Volts/div position. x10 magnifier increases sensitivity of each deflec?tion factor setting to 500V/div. Accuracy xl ±2% (+10°C to +35°C) ±4% (0°C to +50°C) x10 ±3% (+10°C to +35°C) ±5% (0°C to +50°C) Additional error for magnifier ±1% Display modes: CH1, CH2 (normal or invert), Alternate, Chopped (250kHz rate), Added Input Impedance: 1M ohm ±1.5% in naraHel with 2.8nF ±3PF Maximum Input Voltage: 250V (DC + AC peak) or 500Vp-p AC at 1kHz or less Input coupling: AC-GND-DC Delay Line: Permits viewing leading edge of display waveform. Four-trace Display (TRIG VIEW) Display simultaneously channel 1, channel 2, channel 3 (A EXT TRIG signal), channel 4 (B EXT TRIG signal). The deflection factor of channel 3 and channel 4 is approx. 200mV/DIV. ? Sensitivity INT: 1/1 ± 30% of screen area EXT: 0.2 V/DIV ± 30% ? Frequency band EXT: DC to 70 MHz (-3dB) ? Position CH3: Horizontal 100% graticule line of screen ± 1 div (trigger level knob is set at the center). CH4: Horizontal 0% graticule line of screen ± 1 div.